Blackhawk AXIOM U/L RIFLE STOCK CAMO FINISH Manuel d'utilisateur télécharger pdf

www.BLACKHAWK.com

BLACKHAWK!

NORFOLK, VA U.S.A. 1.800.694.5263

50107098 REV. 04.09

AXIOM Rifle Stock

Owner’s Manual

™

Page 1

www.BLACKHAWK.com

BLACKHAWK!

NORFOLK, VA U.S.A. 1.800.694.5263

Installation Instructions

ATTENTION: Read and follow all instructions and warnings prior to installation and/or fir-

ing a Axiom equipped firearm. Take extra time to review the shooting tips & techniques

section of this manual (Page 7). If you are at all unsure of your ability to install your Axiom

Rifle Stock safely, please seek the services of a competent gunsmith.

WARNING 1: Before beginning stock installation, make sure that the rifle is UN-

LOADED. Carefully check the chamber and magazine making both visual and touch ver-

ification.

WARNING 2: The Axiom Rifle Stock is not compatible with oversized trigger guards.

Use of the Axiom Rifle Stock with an oversized trigger guard will cause product failure and

possible injury. Note: Most factory installed trigger guards are compatible with the Axiom

Rifle Stock.

WARNING 3: The Axiom Rifle Stock is not compatible with trigger guard mounted

oversized safeties. Use of the Axiom Rifle Stock with an oversized safety will cause prod-

uct failure and possible injury.

TOOLS REQUIRED:

• Large Flat Blade Screw Driver

• Hex Key / Allen Wrench Set

• Torque Wrench (Recommended)

• Extended “ball end” Allen Wrench (Included)

INSTALLATION STEPS:

1. Remove action bolt from receiver. Remove original stock. Refer to manufacturer’s in-

structions for the best method to remove stock. Normally the barreled action is held in po-

sition by two screws located on the bottom of the stock. Using caution not to damage

screws, use the appropriate size and type of tool to remove the two screws (Fig. 1A).

Note: At this point the trigger guard is disconnected from the stock. For BDL models re-

move bottom magazine floor plate along with magazine housing. (Fig. 1B on the follow-

ing page) Remove barreled action from stock. To avoid damage, take caution when

removing barreled action from original stock.

Fig. 1A

1 2 3 4 5 6

Résumé du contenu

Page 1 - AXIOM Rifle Stock

www.BLACKHAWK.comBLACKHAWK!®NORFOLK, VA U.S.A. 1.800.694.526350107098 REV. 04.09AXIOM Rifle StockOwner’s Manual™Page 1www.BLACKHAWK.comBLACKHAWK!®NORF

Page 2

www.BLACKHAWK.comBLACKHAWK!®NORFOLK, VA U.S.A. 1.800.694.5263Installation Instructions ContinuedPage 22. Prepare Axiom Rifle Stock for Installation by

Page 3

www.BLACKHAWK.comBLACKHAWK!®NORFOLK, VA U.S.A. 1.800.694.5263Installation Instructions ContinuedPage 46. Reinstall trigger guard and hinged magazine f

Page 4 - Axiom Operational Information

www.BLACKHAWK.comBLACKHAWK!®NORFOLK, VA U.S.A. 1.800.694.5263Axiom Operational InformationPage 6To extend the Stock, grasp the release lever located o

Page 5 - Sling Mounting Tips

www.BLACKHAWK.comBLACKHAWK!®NORFOLK, VA U.S.A. 1.800.694.5263Sling Mounting TipsPage 81. Slit for 1.5” multi-point sling.2. Pre-Install sling stud for

Page 6 - BLACKHAWK!

Page 10www.BLACKHAWK.comBLACKHAWK!®NORFOLK, VA U.S.A. 1.800.694.5263Product Maintenance & InformationMAINTENANCE:Do not attempt to disassemble or

Commentaires sur ces manuels

Pas de commentaire

Blackhawk AXIOM U/L RIFLE STOCK CAMO FINISH Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Sports et loisirs Blackhawk AXIOM U/L RIFLE STOCK CAMO FINISH. BLACKHAWK! AXIOM U/L RIFLE STOCK CAMO FINISH User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Sports et loisirs Blackhawk AXIOM U/L RIFLE STOCK CAMO FINISH